What's everyone's thoughts on the extra height. I know the quality goes to step but is the ls3 any different than what's out there ?
Step steel and tuuk LS3 steel
Started by bluelinearmy, Apr 24 2013 06:16 PM
4 replies to this topic
#2
Posted 24 April 2013 - 06:25 PM
The LS3 Steel was supposed to be Bauer's version of Step Steel. I haven't heard much about it but its supposed to be comparable to Step Steel
Phrasing people! Phrasing!!!
#3
Posted 24 April 2013 - 07:18 PM
So I skated on them today and profiled them before I went out but not sure if u has the same feeling - could feel the Ice alot more all the cracks and bumps and it seemed like it was harder to snap into a turn end of the skate my feet were pretty sore. I know I won't be used to it right away but did u guys feel somewhat the same feeling
#4
Posted 24 April 2013 - 09:41 PM
I'm having steep installed at the shop now , I've asked for it to be grounded down a tad.
I personally don't like feeling high up. Plus it mess with my stick lengths n such,
I personally don't like feeling high up. Plus it mess with my stick lengths n such,
#5
Posted 01 May 2013 - 09:21 PM
Skated for the first time in them today also with a brand new boot ....
The height was amazing , not an issue as I thought it would be.
Tight hard turns where I'd usually lose an edge , did not happen.
I was on the ice for 2 hours just skating trying to break the skates in so
I put them to the test,
Only issue for me was my stick was too short now so an ex extension of just .5 an inch was added later.
The height was amazing , not an issue as I thought it would be.
Tight hard turns where I'd usually lose an edge , did not happen.
I was on the ice for 2 hours just skating trying to break the skates in so
I put them to the test,
Only issue for me was my stick was too short now so an ex extension of just .5 an inch was added later.
