Whats up everyone,
I was hoping for some advice in fixing the spine protector with my Bauer Apx2 Pants. For some reason on the Apx2s, the belt and spine protector are different than the x60s (only talking about the Vapor line pants). The spine protector is always in a forward leaning position (see attached). The problem with the spine protector leaning forward is that my shoulder pads can never sit right. Typically the back of the shoulder pad goes close to your body and the spine protector goes over it (picture of ovi attached), but with mine, the spine protector leans so far forward to my back that it doesn't allow my shoulder pads to sit and causes them to rise up.
Any suggestions? Do I have to remove the protector? I am not sure what else to do.
Also, I did stitch 420d nylon over the flames stripes. So that is pretty cool
Thanks in advance
Attached Files
-
IMG_5016 (4).jpg 115.63KB
1 downloads
-
IMG_5017 (4).jpg 130.69KB
1 downloads
-
091613_ovechkin.jpg 64.59KB
1 downloads
