5 replies to this topic

[afrozenpond]

Prefer like new with no labels. I can live with like new and side labels. I see a labeled one on ebay but Im trying here first. Thank you.

[JoeyJ0506]

Prefer like new with no labels. I can live with like new and side labels. I see a labeled one on ebay but Im trying here first. Thank you.

A little nail polish remover will bring that side-branding right off of a 4500.

A heat gun on low, or a hair dryer will get the labels up without leaving behind residue.

[afrozenpond]

Im sold. Thanks

[Golden Gate Sharpening]

I second the nail polish remover/acetone. If you go slowly and use a q-tip within the Bauer logo, it'll look like the logo was never there. Wipe it down with a microfiber cloth and water when you are done. Avoid using a magic eraser because it'll take off the clear finish. Use the heat gun to remove the stickers and then use clear tape to remove any remaining sticky residue. Rub the clear tape with your finger, let it sit for a few seconds, then peel it off. The residue should come right off on the tape. Rinse and repeat. 

[afrozenpond]

Great stuff. Thanks.

[afrozenpond]

Closed.