Hey Guys , received a new pair of pro stock FT2's today. bought them without steel , tried to put in a pair of used stepsteel & a pair of new tydan XS runners. speedblade xs holder dial would not tighten up with both set of runners , watched 2 different video's how to take dial parts out & it will not come out. What is the secret to this !
Speedblade XS dial replacement
#2
Posted 06 May 2023 - 10:51 PM
If the mechanism itself works fine, I’d try putting the skates on with the steel in, and then tightening. Sometimes some weight on the heel will seat the steel properly.
Good Idea; Whistling while you work.
Bad Idea; Whistling while you eat.
#3
Posted 06 May 2023 - 11:09 PM
#5
Posted 07 May 2023 - 11:15 AM
Are you able to manipulate it open and closed with out the steel? Does the mechanism extend out from the rear pillar of the holder, also is it stuck outside the holder?
If the mechanism itself works fine, I’d try putting the skates on with the steel in, and then tightening. Sometimes some weight on the heel will seat the steel properly.
Put skates on with Tydan runners , tightened up skates & runners were able to lock in the SB XS dial , still can't get Stepsteels to lock in , going to ask my skate guy what he thinks , when I go to get Tydans sharpened
#7
Posted 07 May 2023 - 12:07 PM
I use Step and it takes some pressure to get it in there enough to dial it down all the way, can't do it just by squeezing/pressing the blade in by hand, always have to press the boot down on something to get enough force. I just had one holder replaced and that one takes twice the effort, I'm guessing the other has been broken in by now.
- Jon