No problem! For the holes I used standard stuff, but made sure to drill them not too big so the nut fits tight enough.
Legend
Member Since 26 Aug 2014Offline Last Active Feb 19 2023 11:05 PM
13 July 2015 - 06:48 PM
No problem! For the holes I used standard stuff, but made sure to drill them not too big so the nut fits tight enough.
08 July 2015 - 05:27 PM
I did this on my helmet too and yes, had to drill holes myself. For the lower holes of the visor, I used the ear loop holes. For the upper holes, in the first place I positioned the visor about where I wanted it to fit by tightening the screws in the ear loop holes, and then I traced dots and I drilled holes. The result was great. I think this is the best way to go if you want to be sure your holes will fit when you put your visor on.
01 July 2015 - 11:25 AM
Bump
17 May 2015 - 06:53 PM
Still looking...!